Fillet

In one sentence: Creates a tangent fillet arc between two existing Draft lines that share or nearly share a corner endpoint.

---

Overview

Workbench: Draft
Menu: Draft → Drafting → Fillet
Command: Draft_Fillet

Joins two lines with a circular arc of a given radius, trimming each line back to the tangent point. The lines must share or nearly share an endpoint (the corner to be filleted).

---

Parameters

Parameter	Description
Radius	Radius of the fillet arc
Delete original wires	Remove the original lines after filleting

---

Common mistakes and pitfalls

Lines too short for the radius

If the lines are shorter than the fillet radius allows, the fillet cannot be created. Reduce the radius or lengthen the lines.

---

See also

• Wire — polyline with built-in Fillet Radius property
• Arc — place arcs manually
• Draft Workbench — workbench overview